2 Hardware Installation
System requirement
•
LAN or WAN Internet to connect server, via PC Ethernet (network card or network cable) TCP/IP protocol(Windows
/NT/2000/XP or later) connect , suggest Internet Explorer 5.0 version or later.
•
Monitor and PC configuration:
CPU: PⅢ or later, RAM: 512M or later (above DirectX8.1)
•
Monitor: 1920×1080 resolution
•
Operation system: Windows NT, Windows2000, Windows XP, Windows 7.
Installation environment
Installation environment requirements
Far away from high-temperature resource and environment; improper place for ventilation; avoid install on shaky place.
Recommend operating environment
-30°C ~ +60℃
Hardware installation steps
Please make sure LAN and WAN are working before installation of the Network High Speed Dome. After checked all the
network system in good condition, keep your hands clean and dry, following the steps bellow.
•
Unpack the box to check the goods
•
Take out all goods which needed for installation from the box
•
Take off the protection cover and insert the SD card (if need). Please refer to the SD card installation steps below.
Figure 1
Figure 2
Remove the screws with "7"
wrench
Remove the screws here
2