–
Make sure an appliance mounted on a tank is securely installed before
operating it.
–
Read and observe all the important notices on the appliance and its cord.
–
If an extension cord is necessary, a cord with a proper rating should be
used.
cord rated for less amperes or watts than the appliance rating
may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled.
–
Check that the voltage shown on the label of the unit corresponds to the
voltage of the mains supply.
–
Disconnect all electrical appliances from the mains before placing hands
in the water.
–
The line cord of this unit cannot be replaced or repaired. Should the line
cord become damaged the appliance must be discarded.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Safety instructions
device. Keep these operating instructions in a safe place.
For indoor use only. For use with aquariums.
ll electrical equipment in the water must be disconnected from
the mains during care and maintenance work.
The connecting line of this device can not be replaced. When the
line is damaged, the device must no longer be used. Never carry
the pump by the cable; do not bend the cable.
The pump should not run dry. Temperature range from +4°C up
to max. +35°C. The motor is protected from overheating.
Read the operating and safety instructions carefully
and comply with all instructions prior to operating this