Press Exit (1) until the warewasher exits Commissioning Mode
and returns to the off state.
5.4
Priming the Chemical Pumps
Before the warewasher can be used the chemical tubes need to
be filled with chemicals, in order to do this you will need to follow
the instructions given below to prime the chemical pumps.
Enter Commissioning Mode - press and hold the Exit (1) and
Enter (2) buttons simultaneously for 3 seconds (►5.2).
Using the Up and Down keys (5 and 6), scroll to the rinse aid
prime menu (rP0) and press Enter (2)
The display will flash and will change to 1.
This will start and run the Rinse Aid Pump for a maximum of 12
minutes, drawing chemical into the warewasher. When the
chemical has reached the back of the warewasher (the chemical
is visible through the tubing), press Enter (2) again to stop the
Pump.
The display will stop flashing and revert to rP0.
Using the Up and Down keys (5 and 6), scroll to the detergent
prime menu (dP0) and press Enter (2).
The display will flash and will change to 1.
This will start and run the Detergent Pump for a maximum of 2
minutes, drawing chemical into the warewasher. When the
chemical has reached the back of the warewasher (the chemical
14
Classeq Under Counter Range - User Manual
is visible through the tubing), press Enter (2) again to stop the
Pump.
The display will stop flashing and revert to dP0.
Press Exit (1) until the warewasher exits Commissioning Mode
and returns to the off state.
5.5
Integral Water Softener (if fitted)
5.5.1
Commissioning the water softener unit
To commission the Water Softener unit follow the instructions
below:
1.
Open the door to the warewasher.
2.
Remove the right hand Basket Guide.
3.
Remove the Salt Reservoir Cap at the back right hand
corner of the Wash Chamber.
4.
Fill the Reservoir with fresh water.
5.
Using the Water Softener Funnel supplied, fill the
Reservoir with approximately 1.5kg of granulated salt.
6.
Wipe away any excess or spilt salt from the Wash
Chamber and the Reservoir opening.
7.
Refit the Salt Reservoir Cap, ensuring that the Cap is
fitted flat and secure.
8.
Do not overtighten the Salt Reservoir Cap.
Caution
DO NOT run the
in the salt reservoir, as this will allow limescale
to build up. Limescale deposits in the
warewasher
Caution
DO NOT add any chemicals, such as detergent
or rinse aid to the reservoir. These will cause
damage to the warewasher.
warewasher
if there is no salt
will invalidate the warranty.