Classeq D400 Manual De Usuario página 31

Classeq Under Counter Range - User Manual
Problem Possible Cause
Warewasher runs
through a full cycle
but does not rinse.
Warewasher Wrong Drain Plug
overflowing. fitted.
E16
Primary /
Secondary Filters
blocked.
There is a problem
with the drains
system.
Poor wash results. Warewasher not
being supplied with
soft water.
There is a problem
with the wash and
rinse aid chemicals
system.
Solution / Check
If your warewasher
runs through a full
cycle, but does not
rinse, you will need
to request a service
callout to identify
the root cause of
the problem.
Check that the Drain
Plug is the right one
for the warewasher
(►4.6).
Check the Primary /
Secondary Filters - if
blocked remove and
clean thoroughly.
Check that the
warewasher waste
hose is not kinked
or blocked.
Check that the site
waste is not
blocked.
If the warewasher
continues to
overflow isolate the
warewasher and
request a service
callout.
Check the operation
of the Water
Softener (external or
internal) if fitted.
If external,
regenerate the
Water Softener.
If internal, check /
refill the Salt
Reservoir.
Check the level of
chemicals within the
detergent and rinse
aid bottles.
Ensure the bottle
weights and tubes
are correctly
positioned.
Check the chemical
dosing rates are
correctly set (►5.3).
Problem Possible Cause
Warewasher not
properly cleaned.
Warewasher does Wrong Drain Plug
not drain. fitted.
Primary /
Secondary Filters
blocked.
There is a problem
with the drains
system.
Ball in anti-syphon
device dirty /
blocked (pumped
drain warewashers
only).
Warewasher will There is a problem
not turn off when with the
the On/Off button warewasher's
is pressed. control / electrical
system.
Solution / Check
UK
Ensure that the
warewasher is
regularly cleaned
(►7.2).
Check for presence
of beige or black
film deposits around
the door and door
hinges of the
warewasher
indicating a build up
of growing yeast
cells.
Check glasses and
renovate if required.
Check that the Drain
Plug is the right one
for the warewasher
(►4.6).
Check the Primary /
Secondary Filters - if
blocked remove and
clean thoroughly.
Check that the
warewasher waste
hose is not kinked
or blocked.
Check that the site
waste is not
blocked.
Correct drain
procedure is being
used for the
warewasher type
(►6.9).
Remove the anti-
syphon device cover
inside the
warewasher, gently
clean the ball by
inserting and
agitating a small
bottle brush, flush
using a trigger spray
bottle with a jet
nozzle.
Isolate the electrical
supply to the
warewasher, turn
off the water supply,
and request a
service callout.
25