A) Code Options; Programming The Monitor - Fermax CITYLINE VDS SMILE Serie Manual De Instalador Y Usuario

SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS
Notes:
- After entering 3 continuous erroneous codes the monitor will be blocked for 5 minutes.
- RESET the Administrator code.
remember it, you may restore the default code. Enter the default code 3 times (4444),
even if an error appears (showing the digits in red).
3. Once the installer has accessed the configuration menu screen, the screen options
appear, (use the cursor to move them). The firmware version appears in the right
corner of the screen:
.
b
a
d e
Default selection:
a) code options (white line under the icon). Press . The following screen will appear:
0 0 1
a1
_ _ _
2222
4444
Note: Navigation buttons and capacitive buttons
Navigation buttons
capacitive buttons
PROGRAMMING THE MONITOR: Option a2): From the panel
0 0 1
_ _ _
2222
4444
Page 26
If the installer has changed the code and does not
FW v1.0
c
f
There are two monitor programming
options:
a2
Option a1): From the Monitor. See advanced
manual cod. 97711 in www.fermax.com
Opción a2): From Panel + Monitor.
a.1) Programming the monitor from the
a.2) Programming the monitor from the panel.
3. In order to select programming from the
g
monitor itself.
The icons viewed on the screen
(navigation buttons: , ,  y ), are
managed with
capacitive buttons located on the monitor
panel, select the panel from the VDS # line
with the right arrow.
FW v1.0
the corresponding