Makita CL107FD Manual De Instrucciones página 6

To start the cleaner, simply push the ON/speed change
button. To switch off, push the OFF button.
You can change the cleaner speed in three steps by
pushing the ON/speed change button.
The first push on this button is for high speed mode, the
second push for max speed mode and the third push
for normal speed. Each push on this button repeats the
high/max/normal speed cycle alternatively.
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
3
► 1. ON/speed change button 2. OFF button 3. Lamp
To turn on the lamp, push the ON/speed change button.
Push the OFF button to turn off the lamp. During the
tool actuating, the lamp turns on.
When the remaining battery capacity gets low, the lamp
starts blinking.
NOTE: The timing, at which the lamp starts blinking,
depends on the temperature at work place and the
battery cartridge conditions.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Disposing of dust
CAUTION:
Empty the cleaner before it
becomes too full, or the suction force weakens.
CAUTION:
Be sure to empty the inside of the
cleaner itself of dust. Failure to do so may cause the
filter to be clogged or the motor to be damaged.
CAUTION:
Never throw away the dust stopper
because it should be used whenever either the
dust bag or the paper filter is used.
CAUTION:
When closing the front cover, be
careful not to pinch your fingers.
1.
Push the button to open the front cover. Opening
it until a click is heard allows a positive stop at that
position.
2
► 1. Front cover 2. Button
2. Pull out both the orange-colored dust stopper and
dust bag together at the same time.
1
2
1
► 1. Dust stopper
3. Remove the dust stopper and empty the cleaner.
1
► 1. Dust stopper
6 ENGLISH
1