Makita CL107FD Manual De Instrucciones página 7

NOTE: The cleaner is constructed in such a way that
the front cover comes off when trying to force the
front cover open at the angle of more than 90°. If the
front cover comes off, insert it into the front cover joint
in place.
► 1. Front cover 2. Front cover joint
Dust bag and paper filter
Install either dust bag or paper filter before using
cleaner.
Use the dust stopper when installing either dust bag or
paper filter.
Dust bag are usable many times repeatedly by cleaning
it out.
Paper filter is a throw-away type. Throw away the entire
paper filter without emptying when it has become full.
NOTICE:
To prevent dust from getting into the
motor:
• Make sure that the dust bag or paper filter is
installed before use.
• Insert the dust stopper together with the
dust bag or paper filter all the way into the
slots when installing them.
• Do not use a broken or ripped bag.
Otherwise the motor may be broken.
NOTICE:
Do not fold the cardboard at its open-
ing when installing the paper filter.
NOTICE:
Never throw away the dust stopper
because it need to be used repeatedly whenever
either the dust bag or the paper filter is used.
NOTICE:
The paper filter for the cleaner is an
important component for maintaining the tool
performance. Using other than the genuine paper
filter may cause smokes or ignition.
Installing dust bag
Use the dust stopper when installing dust bag. Be
careful not to take the upper side for the lower side by
mistake because they are different each other.
1
2
► 1. Upper side of dust stopper 2. Lower side of dust
stopper
1.
groove in the dust stopper as shown in the figure.
► 1. Dust stopper 2. Groove 3. Dust bag
2.
lower sides of the dust bag. You may insert its protru-
sion of either side into the lower groove of the dust
stopper.
► 1. Lower groove
3.
dust bag.
7 ENGLISH
1
2
Insert the protrusion of the dust bag into the
1
2
There is no distinction between the upper and
Overlap the frame of dust stopper with that of the
3
1