Settings; Centring Adjustment; Internal Clamping - Garant XTRIC Manual De Instrucciones

6. Settings

6.1. CENTRING ADJUSTMENT

Hexagon L-wrench size 3, pin wrench (No. 628600 2) straight
Z
Fig. 5: Centring adjustment
1. Using the hexagon L-wrench, release the clamping screw.
2. Using the pin wrench, perform the desired adjustment.
» Refer to the direction of setting shown by the engraving on the centring vice.
3. Using the hexagon L-wrench, tighten the clamping screw.

6.2. INTERNAL CLAMPING

Hexagon L-wrench size 5
1
Tab. 3: Changing over to internal clamping
1. Using the hexagon L-wrench, unscrew the spindle nuts from the spindle.
2. Turn both spindle nuts through 180°.
3. Insert the spindle nuts into the guide and use the hexagon L-wrench to screw them on to the
spindle.
Z
2
1
3
2
www.hoffmann-group.com
3
en
23