Important Safety Instructions; Special Instructions - Singer Expert Finish Manual De Instrucciones

IMPORTANT SAFETY INSTRucTIONS

When using your flatiron, basic safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING.
Save these instructions in a safe place for future reference.
1. Use appliance only for its intended use.
2. To protect against risk of electrical shock, do not immerse the iron in water
or other liquids.
3. This appliance should always be turned to "OFF" before plugging or unplug-
ging from an outlet. Never yank the cord to disconnect from outlet, always
grasp plug and pull to disconnect.
4. Always disconnect the appliance from the electrical outlet when filling with
water or emptying or when not in use.
5. Do not allow cord to touch hot surfaces. Let the iron cool completely before
putting away. Loop cord losely around iron when storing.
6. Do NOT operate appliance with a damaged cord, or if the appliance has
been dropped or damaged. If electrical cord is damaged it must be replaced
by the manufacturer or authorized service agent to avoid a safety hazard.
7. To avoid the risk of electrical shock, do NOT disassemble the iron. Ship to
the nearest authorized SINgEr
and repair. Incorrect reassembly or repair can cause a risk of fire, electrical
shock, or injury when the appliance is used.
8. Not intended for use by children. Close supervision is necessary for any
appliance being used near children. Unsupervised use can result in fire or
personal injury. Do not leave appliance unattended while plugged in, on an
ironing board, or while it is still hot.
9. Burns can occur from touching hot metal parts, hot water or steam. Use
caution when you turn a steam iron upside down as there may be hot water
in the reservoir.
10. Never use or rest the iron on an unstable surface.
11. When iron is hot, never set on an unprotected surface.

SPECIAL INSTRUCTIONS:

To avoid a circuit overload, do not operate another high-wattage appliance on the
same circuit. If an extension cord is absolutely necessary, a 15-amp cord should
be used. Cords rated with less amperage may overheat. Use care to arrange the
cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
WARNING: ThE pOWEr COrD ON ThIS prODUCT CONTAINS LEAD, A
ChEmICAL kNOWN TO ThE STATE OF CALIFOrNIA TO CAUSE BIrTh DEFECTS
Or OThEr rEprODUCTIvE hArm. WASh hANDS AFTEr hANDLINg.
FOR HOUSEHOLD USE ONLY
2
® approved service center for examination
Getting to Know Your SINGER
2
3
4
5
6
9
7
12
1. Soft grip handle
2. Burst of Steam Button
3. Cool mist Spray Button
4. LCD Display panel
5. Water Inlet Cover
6. Spray Nozzle LCD PANEL DESCRIPTION
7. Temperature Up/ON-OFF
Button
8. Temperature DOWN Button
9. variable Steam Control &
Self-Cleaning Dial
D
10. heel rest
11. 360° Swivel Cord
12. Soleplate
TECHNICAL SPECIFICATIONS: voltage: 120v, 60 hz
WARNING: TO AvOID FIrE, NEvEr LEAvE IrON UNATTENDED WhILE
pLUggED IN.
Iron
®
1
11
7
A B c
A. Steam Indicator
B. Anti-Scale Indicator
C. Auto-Off Indicator
D
D. Temperature Level
Indicator
E
E. Fabric guide
power: 1700 Watts
10
8
3