Cool Mist Spray
The Cool mist Spray function can be used on any temperature setting. Use the
spray to dampen fabrics in order to remove tough wrinkles.
•
Aim the nozzle at the garment.
•
press the Cool mist Spray Button. You may need to press the button a few
times before the water sprays at full pressure.
•
Iron as usual.
•
Do not spray silk.
Cool mist Spray Button
3-Way Smart Auto-Off
The SINgEr Expert Finish Iron is equipped with an automatic shut-off. The
Smart Auto-Off switches the iron off if it has been left unattended.
NOTE: Auto-Off is not an on/off switch. Always unplug the iron when it is not
in use.
•
If the iron is left on and is not moved for 8 minutes in a vertical position, it will
automatically shut off and an audible beep will sound.
•
If the iron is left on its soleplate or tipped over, it will shut off after 30 seconds
and an audible beep will sound.
•
When the iron is preparing to shut off, the Auto-Off symbol will start flashing
on the LCD Display panel with an audible beep sound. The LCD back light
will turn off after 5 seconds.
•
To de-activate the Auto-Off, move the iron or shake gently. The iron will take
about 60 seconds to reach the previous soleplate temperature.
•
To turn the iron off, press and hold the Temperature Up/ON-OFF for 3
seconds. The LCD Display will turn off and an audible beep will sound.
10
cool mist spray
Anti-Drip
This iron is designed to reduce dripping and spitting while in use. Steam is
automatically disabled when the soleplate temperature is too low to create
steam, preventing spitting or dripping.
The Anti-Drip system may make a loud clicking sound during use. This is normal
and indicates that the system is functioning correctly.
Anti-Scale System
The built-in Anti-Scale cartridge is designed to reduce the buildup of mineral
substances in the water which occurs during steam ironing, thereby extending
the life of your SINgEr Expert Finish Iron. however, please note that the
anti-scale cartridge will not completely stop the natural process of lime scale
buildup.
clEANING AND STORAGE
Self-Cleaning
This feature removes loose minerals and other impurities that have been built
up in the steam chamber. It is recommended that this function be performed at
least once a month or more regularly depending on the hardness of the water
used.
WARNING: ThE SELF-CLEAN FUNCTION WILL CAUSE hOT STEAm AND
WATEr TO BE EJECTED FrOm ThE SOLEpLATE. TAkE ALL prOpEr
prECAUTIONS AND hOLD IrON AWAY FrOm BODY. STEAm AND WATEr
ArE vErY hOT AND CAN CAUSE BUrNS.
•
Fill the water tank half full, as described in the "Filling the Water Tank"
section.
•
place the iron on its heel on a flat surface.
•
plug the iron into a grounded outlet.
•
The LCD Display will show all symbols and then turn off with an audible beep
sound.
•
Select temperature 9 using the Temperature Up and DOWN buttons.
11