Serial Numbers - Peg-Perego Booklet 50 Instrucciones De Uso

brake on the chassis and lift it to release the
brake.
20 ADJUSTABLE HANDLEBAR: To adjust the
height of the handlebar, press both of the
side buttons at the same time (fig_a) and
swing it into the desired position (fig_b), then
release the buttons.
21 FOOTREST: before adjusting the foot rest,
ensure its cover is accurately fitted; if it isn't,
fit it accordingly. To lower the footrest push
the two levers downwards and then push
the footrest downwards (fig_a); to raise the
footrest lift it upwards (fig_b).
It can be adjusted into several positions.
22 ADJUSTING THE BACKREST: to lower the
backrest, press the clip and the backrest will
move down to the desired position.
To raise the backrest, press the clip and lift
the backrest to the desired height.
23 FIVE POINT SAFETY HARNESS: to fasten it,
push the two waist strap buckles (with the
shoulder straps attached – arrow_a) into
the leg divider until they click into place
(arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c)
and pull the waist straps out (arrow_d).
24 To tighten the waist strap, pull on both sides
in the direction of the arrow (arrow_a). To
loosen it, move it in the opposite direction.
To adjust the height, slip the belts through
the eyelet in the fabric (fig_b) and position
them in the most suitable eyelet.
The seat belts are fitted with shoulder pads
and crotch straps (fig_c).
25 FOLDING UP: To fold up the stroller, we
recommend ensuring the front wheels swivel,
closing the hood, removing the car seat when
fastened.
Align the handlebar and frame as shown in
the figure (fig_a).
Rotate the safety lever to the left (fig_b) and
pull the internal handle towards yourself (fig_c).
26 Allow the handlebar to fall in on itself until
fully folded (fig_d).
The frame is folded correctly when the
side fastener automatically locks (fig_e).
Otherwise, gently press down on the frame
(fig_f).
The stroller is free-standing when folded.
27 For greater compactness, it is possible to
remove the wheels.
To remove the rear wheels: pull the pivot
outwards and remove the wheel as shown in
the figure (fig_a).
To remove the front wheels: press the tab as
shown, and remove the wheel (fig_b).
TRANSPORT: the stroller can be carried
comfortably locking the front wheels and
grasping the main handle (fig_c).
28 REMOVABLE ITEMS: to remove the hood, take
the elastic off from the buttons on the inside
of the handlebar (fig_a), detach the press
studs the sides of the chassis (fig_b), detach
the Velcro strip from the backrest (fig_c) and
remove the attachments of the hood from
their positions on the chassis (fig_d).
29 To remove the seat fabric, press in the holes
on the inside of the chassis (fig_a); remove,
from the side of the seat, the rigid flap of the
chassis fabric ((fig_b), unfasten the elastic
of the net from the side buttons inside the
handlebar (fig_c) and unfasten the elastics
from the buttons inside the chassis (fig_d).
30 From the front, remove the lining from the
foot platform (fig_a), remove the leg divider
strap from under the seat (fig_b), unbutton
the seat fabric (fig_c), unscrew the waist belt
on the side (fig_d) and remove the seat fabric
from the backrest (fig_e).
GANCIOMATIC SYSTEM
The Ganciomatic System offers a fast,
practical means of fastening a Primo Viaggio
4.35 - Primo Viaggio 4.35 nido car seat
(sold separately) to the stroller, using the
Ganciomat attachments.
31 GANCIOMATIC HOOKS ON THE STROLLER:
to lift the stroller's Ganciomatic hooks, pull
back the fabric at the corners of the seat.
Lift the two Ganciomatic hooks which will
automatically move outwards.
_ To lower the hooks, proceed in the opposite
order.
32 Booklet 50 + Primo Viaggio
To fasten the car seat to the stroller:
_ Lock the stroller brakes;
_ Lift the stroller's Ganciomatic hooks:
_ Extend the front bar into position 2 (see point
12).
_ If in place, remove the hood from the stroller
and fully lower the backrest. Once the seat
has been fastened, lift the backrest to the
maximum height .
_ Position the car seat, mum-facing, on the
Ganciomatic hooks and press down until they click.
_ To release the car seat from the stroller please
read the instructions book

SERIAL NUMBERS

33 Information about the production date can
be found on the Booklet 50.
_ The product name, production date and serial
number of the chassis.
This information is required for any
complaints.
THE ORIGINAL ACCESSORY
PEG-PÉREGO
Peg-Pérego accessories are designed as a
useful, practical means of simplifying the
- 16 -