Tabla de contenido
Publicidad
INSTALLATION OF COUNTER WEIGHT
5.
SLIDE IN THE COUNTER WEIGHT COMPLETELY INTO THE REAR OF THE TONE ARM UNTIL IT REACH
THE END，TURN IT CLOCKWISE UNTIL IT CLICK WITH PIT INSIDE.
6.
TWIST THE COUNTER WEIGHT CLOCKWISE & BACKWARD UNTIL IT REACH THE WHITE LINE AS FIGURE
2
7.
TWIST THE COUNTER MARKING UNTIL IT REACH " 1 " POSITION
8.
TWIST THE COUNTER WEIGHT ANTI-CLOCKWISE & INWARD UNTIL IT REACH THE APPROPIATE
WORKING PRESSURE.
REMARK : THE WORKING PRESSURE OF THE PROVIDED STYLUS IS FROM THE RANGE 4 – 6 GRAMS
ACCORDING TO THE CARTRIDGE MANUFACTURER. ALL STYLUS HAS IT OWN WORKING
PRESSUE AND PLEASE REFER TO THE SPECIFICATION RESPECTIVELY.
CONNECTION
1.
CONNECT THE POWER CORD (36) TO AC OUTLET AND CONNECT THE SPEAKER WIRE TO THE
SPEAKER TERMINAL (33) LOCATED ON THE REAR SIDE OF UNIT.
2.
PRESS THE POWER BUTTON (10) AND IF STANDBY LED INDICATOR (10) LIGHT OFF, IT'S MEAN THE
POWER SUPPLY IS NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.
SETTING THE CLOCK
1.
SET UNIT IN STANDBY MODE.
2.
PRESS & HOLD THE "MEM/CLK-ADJ" BUTTON (12), THE LCD DISPLAY (2) WILL SHOW " SET CLOCK " AND
THEN DISPLAY " 12HR OR 24 HR " PRESS SKIP
APPROPIATE AREA HOUR FORMAT(12HR/24HR). PRESS "MEM/CLK-ADJ" BUTTON (12) AGAIN TO
CONFIRM.
3.
THE LCD (2) WILL DISPLAY THE FIRST & SECOND DIGIT OF "00" IS FLASHING. PRESS SKIP
SKIP
BUTTON (17/19) TO SET THE CORRECT HOUR. PRESS "MEM/CLK-ADJ" BUTTON (12) TO STORE
THE CORRECT HOUR.
4.
THE THIRD & FOURTH DIGIT OF "00" IS FLASHING, PRESS THE SKIP
SET THE CORRECT MINUTES. THEN PRESS "MEM/CLK-ADJ" (12) TO STORE THE CORRECT MINUTE.
THE PRE-SET TIME WILL BE RE-SET COMPLETELY IF DIS-CONNECTING THE MAIN POWER
SUPPLY. YOU ARE RECOMMENDED TO SWITCH THE SYSTEM INTO STANDBY MODE FOR
CONVENIENCE USAGE.
LISTENING TO RADIO
MANUAL TUNING
1. PRESS FUNCTION BUTTON (11) TO SELECT " TUNER " MODE.
2. TUNE TO THE REQUIRED STATION BY PRESSING THE " TUNING / SKIP UP
BUTTON.
3. ADJUST VOLUME CONTROL (22) TO THE DESIRED VOLUME LEVEL..
AUTO TUNING
1.
PRESS FUNCTION BUTTON (11) TO SELECT " TUNER " MODE.
2.
PRESS AND HOLD THE " SKIP / TUNING UP
THEN RELEASE.
3.
THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP UNTIL A RADIO STATION IS REACHED.
4.
REPEAT STEP 2 & 3 UNTIL THE DESIRED RADIO STATION IS BEING REACHED.
5.
ADJUST VOLUME UP/DOWN CONTROLS (22) TO THE DESIRED VOLUME LEVEL.
PRESET STATIONS
YOU CAN STORE UP TO TOTAL OF 30 RADIO STATIONS IN THE MEMORY.
1.
SET TO " TUNER " MODE.
2.
TURN TO THE DESIRED RADIO STATION BY " MANUAL" OR "AUTO" TUNING METHOD.
3.
PRESS " MEM / CLK-ADJ" BUTTON (12) TO ENABLE PROGRAM STATE.
4.
PRESS " FOLDER / PRE-UP (13) OR FOLDER / PRE-DOWN
SELECT THE DESIRED STATION MEMORY POSITION FOR STORAGE.
OR SKIP
OR DOWN
(17/19) BUTTON FOR 1-2 SECONDS AND
BUTTON (AT REMOTE HANDSET) TO
EN-2
BUTTON (17/19) TO SELECT THE
OR SKIP
BUTTON (17/19) TO
OR DOWN
OR
(17/19)
Publicidad
Tabla de contenido
