Bosch AHS 18 Accu Instrucciones De Servicio página 9

Product Specification
Shrub shear
Part number (Typ)
Motor Voltage
Cutting length
Cutting width
Running time
Weight
Battery
Nominal Voltage
Charging time (empty battery) 20 h
Intended Use
The product is intended for light trimming of hedges
and shrubs in domestic use.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your hedgecutter. It is impor-
tant that you read these instructions carefully.
Delivered Items
Carefully remove the machine from its packaging
and check for complete contents:
– Shrub shear
– Blade guard
– Charger Cable
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
Operating Controls
1 Shear blade
2 On/Off switch
3 Safety lock
4 Blade guard
5 Handle connection
6 Charging socket
7 Socket for handle switch
8 Screws
9 Housing bottom
10 Release
11 Handle plug
12 Handle
13 Wheels
Not all of the accessories illustrated or described are
included as standard delivery.
9 • 2 609 932 335 • TMS • 03.11.03
AHS 18 Accu
0 600 832 5..
7.2 V DC
175 mm
8 mm
approx. 70 min
1.0 kg
NiCd
7.2 V/1.5 Ah
English - 2
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting or cleaning.
The blades continue to move for a few sec-
onds after the Machine is switched off. Cau-
tion! Do not touch the moving blades.
Before Use
Battery
■ Protect the battery from heat and fire: Danger of
Explosion!
■ Never leave the machine on heaters or expose to
strong sunlight for long periods of time, tempera-
tures of more than 50 °C cause damage. Allow
the heated battery to cool before charging.
■ Avoid repeated consecutive rapid charges of the
battery. Do not recharge after using only briefly
(e. g., 3 minutes).
■ Charge the battery just before using the machine;
this ensures that the battery is at its maximum
performance capability.
■ Long service life is achieved when the battery is
regulary loaded and then recharged.
■ A considerably short operating life in spite of re-
charging indicates that the battery is dead and
must be replaced.
■ Observe the notes on environmental protection.
Charge battery.
Always use the correct supply voltage: The volt-
age specification on the type rating plate must be the
same as that of the electric supply line.
A new battery produces its full power after approx.
five charging and discharging cycles. This also ap-
plies for batteries that have not been used for a long
time.
When used correctly, the battery can be recharged
up to 1000 times.
Insert mains cable into charging socket 6 and con-
nect to a wall socket (see fig.
equipment while charging.
After the completion of the charging process (ap-
prox. 20 hrs. for an empty battery), remove the
mains cable from the socket and from the machine.
If the machine remains connected to the mains after
being successfully charged, this does not damage
the battery but makes no sense because of the un-
necessary energy consumption.
). Do not switch on
B