Cleaning And Maintenance; Down Button - Domo DO7293S Manual De Instrucciones

duct Maintenance
Cleaning Side Brushes
Clean the side brush when it become dirty and replace it if it's damaged. The maximum life span of
de Brushes
ning Side Brushes the side brush is 12 months.
Clean the side brush when it become dirty and replace it if it's damaged. The maximum life span of
Note: Before replacing side brushes, check and ensure that the L/R mark on the side brush match
Charging without a charging station
the side brush is 12 months.
rush when it become dirty and replace it if it's damaged. The maximum life span of
he side brush when it become dirty and replace it if it's damaged. The maximum life span of
Plug the adapter into the contact and insert the DC input into
with the L/R mark on the bottom base of the robot.
Note: Before replacing side brushes, check and ensure that the L/R mark on the side brush match
12 months.
the vacuum.
e brush is 12 months.
de Brushes
with the L/R mark on the bottom base of the robot.
Cleaning Dust Bin and Filters
· While charging:
lacing side brushes, check and ensure that the L/R mark on the side brush match
efore replacing side brushes, check and ensure that the L/R mark on the side brush match
Cleaning Dust Bin and Filters
ush when it become dirty and replace it if it's damaged. The maximum life span of · Display shows flashing '1111': vacuum is charging
k on the bottom base of the robot.
e L/R mark on the bottom base of the robot.
Empty and clean the dust bin after each usage following the steps as show in the figures below:
· Display shows 'FULL': device is fully charged
12 months.
Empty and clean the dust bin after each usage following the steps as show in the figures below:
st Bin and Filters
· Display shows 'Erro': the power switch must be on to
ning Dust Bin and Filters
acing side brushes, check and ensure that the L/R mark on the side brush match
charge
k on the bottom base of the robot.
the dust bin after each usage following the steps as show in the figures below:
and clean the dust bin after each usage following the steps as show in the figures below:

CLEANING AND MAINTENANCE

st Bin and Filters
CLEANING OUT THE CANISTER AND FILTER
the dust bin after each usage following the steps as show in the figures below:
Clean the canister and the filter after each use in the following manner:
1
A. Hold the bottom of dust bin, and press down on the button using your
A. Hold the bottom of dust bin, and press down on the button using your
thumb to take out of the dust bin.
thumb to take out of the dust bin.
m of dust bin, and press down on the button using your
d the bottom of dust bin, and press down on the button using your
ut of the dust bin.
to take out of the dust bin.
m of dust bin, and press down on the button using your
3
t of the dust bin.
C. After press down button
C. After press down button
and o
pen dust bin upper cover
and o
pen dust bin upper cover
5
D. Open dust bin cover and take out the

down button

er press down button
primary filter and HEPA filter.
D. Open dust bin cover and take out the
n upper cover
en dust bin upper cover
down button
primary filter and HEPA filter.
upper cover
F. Wash the dust bin and primary filter under tap water,
F. Wash the dust bin and primary filter under tap water,
clean the HEPA filter with brush, avoid washing it under
clean the HEPA filter with brush, avoid washing it under
1. Press the button that opens the canister. Remove the canister from the vacuum.
water.
water.
2. Press the open button to open the canister.
3. Remove the HEPA filter, including the holder, from the canister.
4. Empty the canister into the waste bin.
bin and primary filter under tap water,
h the dust bin and primary filter under tap water,
5. Rinse the canister and filter holder under running water. Let them dry before putting them back in
bin and primary filter under tap water,
ter with brush, avoid washing it under
he HEPA filter with brush, avoid washing it under
place. Clean the HEPA filter with the dust brush.
ter with brush, avoid washing it under
· If the HEPA filter is dirty, after about 30 days of use, you can also clean it under running water. Let
it dry before putting it back in place.
· The HEPA filter must be replaced after frequent use. The maximum service life of the filter is
approximately 6 months.
40
DO7293S
D. Open dust bin cover and take out the
D. Open dust bin cover and take out the
primary filter and HEPA filter.
primary filter and HEPA filter.
D. Open dust bin cover and take out the
primary filter and HEPA filter.
G. Assemble primary filter and HEPA filter again into
G. Assemble primary filter and HEPA filter again into
G. Assemble primary filter and HEPA filter again into
dust bin.
dust bin.
dust bin.
16
16
16
Clean the side brush when it become dirty and replac
in Fig a.
B. Press the "HOME" button on the remote control or robot to
the side brush is 12 months.
charging docking automatically as shown in Fig b.
Note: Before replacing side brushes, check and ensu
with the L/R mark on the bottom base of the robot.
Cleaning Dust Bin and Filters
Empty and clean the dust bin after each usage follow
Note:
a. When robot is in charging, the LED panel will gradually show
b. When charging is over, the LED panel will show "FULL".
A. Hold the bottom of dust bin, and press down on the bu
c. In standby status, the robot will
thumb to take out of the dust bin.
2
d. In working status, the robot will look for the charging dock au
level is low.
In Order to Extend Battery's Life
a. Please charge the robot for up to 5 hours during the first cha
b. Charge the robot as soon as possible when battery capacity
B. Take out dust bin.
c. The robot will return to the charging dock automatically whe
B. Take out dust bin.
capacity is low.
d. When you do not use the robot for some time, please fu
B. Take out dust bin.
4
switch off the robot and keep it in a cool but dry place.
C. After press down button
e. If the robot has been put aside over 3 months, please ch
and o
pen dust bin upper cover
before using it for cleaning.
6
E. Empty the dust bin.
E. Empty the dust bin.
F. Wash the dust bin and primary filter under tap water,
E. Empty the dust bin. clean the HEPA filter with brush, avoid washing it under
water.
G. Assemble primary filter and HEPA filter again into
G. Assemble primary filter and HEPA filter again into
dust bin.
dust bin.
16 16
Fig a
show
B. Take out dust bin.
B. Take out dust bin.
D. Open dust bin cover
primary filter and HEPA
E. Empty the dust bin.
E. Empty the dust bin.
when the batt
10
G.
du
16