Proper Air Circulation; Parts Included - Haier HT Serie Manual Del Usuario

INSTALLATION INSTRUCTIONS CONT.

PROPER AIR CIRCULATION

To ensure your refrigerator works at the maximum efficiency it was
•
designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections. Your refrigerator is not
designed to operate in temperatures below 55°F (12°C) or above 95°F
(35°C).
Do not install your refrigerator in any location not properly insulated or
•
heated, e.g. garage, etc.
Keep out of direct sunlight and away from heating sources such as
•
radiators, heaters and cooking appliances.
The following are recommended clearances around the refrigerator:
•
Sides and Top .......... 1" (25mm) Back .......... 2" (50mm)
TOOLS NEEDED FOR INSTALLATION
DO NOT USE POWER TOOLS TO INSTALL DOOR HANDLES!
OVERTIGHTENING THE SCREWS COULD STRIP THE THREADS!
Phillips
Screwdriver Screwdriver
(Select Models)
IF YOUR REFRIGERATOR COMES WITH A FACTORY-INSTALLED WATER VALVE AND
TUBING, DO NOT CONNECT A WATER SUPPLY TO THE WATER VALVE ON THE REAR OF
THE REFRIGERATOR UNTIL AN ICE MAKER IS INSTALLED.

PARTS INCLUDED

PARTS INCLUDED MAY DIFFER BASED ON UNIT PURCHASED.
NOTE: Select models may include an extra logo badge.
For models that come with handle mounting
screws installed on the faces of the doors, the
parts included will consist of:
2 handles
•
Front grille
•
4 door edge handle mounting screws
•
Owner`s manual
•
Extra logo badge (select models)
•
T25 Torx
PAGE 6 ● SET UP & USE
Pliers
For models that do not come with handle
mounting screws installed on the faces of the
doors, the parts included will consist of:
2 handles
•
Front grille
•
2 door face handle mounting screws
•
4 door edge handle mounting screws
•
2 handle cover/trim pieces
•
Owner's manual
•
Front Grille
5/16 & 3/8
Or
Wrenches
Adjustable
Wrench