Setting The Stops/Fences; Setting Saw Blade Speed; Setting Cutting Depth Limiting; Connection To A Dust Collection System - Zipper Maschinen ZI-KGS255DS Instrucciones De Servicio

15.2.4 Setting the stops/fences.

15.2.5 Setting saw blade speed

15.2.6 Setting cutting depth limiting

15.2.7 Connection to a dust collection system

For dust extraction in closed rooms, connect a suction hose to the dust extraction nozzle and fix it
with a hose clamp. Connection dimensions according to technical data.

15.2.8 Switch machine ON-OFF

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
The two adjustable stops (9-1) must be adjusted after
changing the machine head angle (90-45°). Loosen the
fixing screws (24) and adjust the stops so that there is a
distance of 8-10 mm between the saw blade and the
stop. Then retighten the fixing screws (24) to fix the
stops (9-1).
CAUTION
Before cutting, check that the stop
bars and the saw blade cannot collide.
(simulated cut with switch-off
machine)
Set the selector switch (28) to the desired speed.
Pos I : 3200 min-1
Pos II: 4500 min-1
The cutting depth can be adjusted continuously with the
screw (22). To do this, loosen the thumb nut (M) on the
screw (22). Turn the screw (22) in or out to set the desired
cutting depth. Then tighten the thumb nut (M) again.
NOTE
Check the setting by performing a test
cut.
Switch machine ON:
Press the lock switch (15) and press the ON/OFF switch
(16) on the handle.
Switch the machine OFF:
Release the ON-OFF switch (16).
OPERATION
30
ZI-KGS255DS