Waeco PerfectCharge IU6 Instrucciones De Uso página 37

_IU6_IU8_IU12_BA_10s.book Seite 37 Mittwoch, 16. Januar 2008 2:06 14
IU6, IU8, IU12
The charging display consists of three LEDs that show the
charging status of the battery:
Display
lower LED flashes
The bottom and middle LEDs
flash
All three LEDs flash
all three LEDs are lit
I
Note
With the conservation charging function, the battery is constantly
recharged to compensate for self-discharging.
I
Note
Observe the following special case:
The charger has a control function that checks the voltage of the
battery before charging. If you connect a battery that is completely
charged (> 13.2 V) or a deep-discharged battery, the charger will
not switch on and the blue charging display remains off.
➤ Switch off the charger.
➤ Remove the terminals from the battery.
Explanation
the battery is almost empty
the battery is approx. 50% charged
the battery is approx. 80% charged
charging is roughly 90% complete
IU6: the battery is fully charged
If the charge current falls below 0.2 A, the
device switches off (the LEDs go out).
IU8, IU12: the battery is fully charged and the
charger switches to conservation charging
mode
All three LEDs remain on.
Using the charger
37