Sound Adjustment - JVC KV-RA2 Manual De Instrucciones

You can adjust the sound characteristics to your preference.
Display unit only
1
Indication
VOL (volume) Adjusts the volume.
BAS*(bass) Adjusts the bass.
TRE*(treble) Adjusts the treble.
FAD**(fader) Adjusts the front and rear speakers balance. R06 (rear only) — F06 (front only)
BAL (balance) Adjusts the left and right speakers balance.
BBE* See "What is BBE?" below.
* Bass sound (BAS), treble sound (TRE) and BBE can be set for CD changer, VCR and
car receiver (AUX) separately.
** When you are using a two-speaker system, set fader (FAD) to "00."
Notes:
• Normally the volume level can be adjusted by pressing the volume buttons. (See page 4.)
• If your car receiver has the same sound adjustment modes as listed above, fix them to the centre
positions or to "OFF" positions.
• For the volume level on your car receiver, fix it to such a level that you can adjust the volume level
properly only with the volume buttons of this unit.
2
Display unit
What is BBE?
The BBE function restores the brilliance and clarity of the original live sound in recording,
broadcasts, etc.
When a speaker reproduces sound, it introduces frequency-dependent phase shifting,
causing high-frequency sounds to take longer to reach the ear than low frequency sounds.
The BBE function adjusts the phase relationship between the low, mid and high frequencies
by adding a progressively longer delay time to the low and mid frequencies, so that all
frequencies reach the listener's ears at the proper time.
In addition, the BBE function boosts low and high frequencies, which loudspeakers tend
to be less efficient in reproducing, through dynamic, program-driven augmentation. When
combined with the phase compensation feature, the resulting sound has a clearer, more
finely detailed "live" presence.
Under license from BBE Sound, Inc.
is a trademark of BBE Sound, Inc.

SOUND ADJUSTMENT

SEL
To do:
Remote controller
Press SEL (select).
Each time you press SEL, the sound
adjustment mode changes as follows.
VOL
BBE
00 (min.) — 50 (max.)
–06 (min.) — +06 (max.)
–06 (min.) — +06 (max.)
L06 (left only) — R06 (right only)
on — oFF
Adjust the level with the volume
buttons.
BAS TRE
BAL
FAD
Range
9