Using The Iu0U Automatic Charger - Waeco PerfectCharge IU152A Instrucciones De Montaje

Using the IU0U automatic charger

10 Using the IU0U automatic charger
You can use the IU0U automatic charger to trickle charge empty batteries or
supply batteries.
NOTE
I
The chargers IU152A, IU252A and IU154A have a charger output
for the starter battery with an output voltage in the range between
13.2 V (26.4 V) and 13.8 V (27.6 V). The charger output for the
starter battery recharges the starter battery with a current of up to
1 A or maintains a high charge level.
➤ Switch on the device with the main switch (fig. 2 1, page 3).
10.1 Setting the IU0U automatic charger (fig. 8, page 7)
Charging voltage and time limit
NOTE
I
Ask your battery retailer for details on the charging voltage and time
limit required for your batteries.
NOTICE!
A
Make sure that the device is never used if DIP switches 1 and 2 or
DIP switches 3 and 4 are both at the "ON" position. Only the switch
positions described in the following tables ensure the correct oper-
ation of the IU0U automatic charger.
➤ Turn the main switch to "0".
➤ Unscrew the four fastening screws (2) from the rear panel using the hex-
agon socket wrench provided.
➤ Remove the rear panel (1).
➤ Use the DIP switches (5) to set the required charging voltage and the du-
ration of the main charging phase (U0 phase, also see "Charging charac-
teristics" on page 51):
48
PerfectCharge
EN