Functional Description; Special Product Features; Selection Of Direction Of Rotation; Switching On And Off - Metabo BE 4006 Instrucciones De Manejo

4 Functional Description

See page 3 (please unfold).
1 Chuck key (for a geared chuck) *
2 Geared chuck *
3 Keyless chuck Futuro Plus *
4 Rotation selector switch
5 Trigger
6 Locking button (continuous activation)
7 Scaffold hook mounting
8 Scaffold hook *
* depending on equipment

5 Special Product Features

• Compact, light machine in barrel-type design
for continuous use
• Ergonomically designed housing with large
trigger switch
• User-friendly routing of machine exhaust air in
every working situation
• Long-life motor
• BE 4006:
Pilot drilling of rivet joints, aluminium, thin sheet
and wood. Ideal machine for assembly work up
to diameters of 6 mm in steel.
• BE 4010:
Perfectly manageable bench drilling machine
for diameters of up to 10 mm in steel.
6 Commissioning
Before plugging in, check to see that the
rated mains voltage and mains
frequency, as stated on the rating label,
match with your power supply.
To guarantee secure purchase of the
chuck: After initial drilling (clockwise), use a
screwdriver to firmly tighten the safety
screw inside the drill chuck. Caution left-
handed thread! (see Section 8.5)
Fitting scaffold hook (8): Clip into the scaffold
hook mounting (7) and turn until it engages in one
of the four positions.
7 Use
7.1

Switching On and Off

To start the machine, press the trigger switch (5).
The speed can be changed using the trigger
switch.
For continuous operation the trigger switch can be
locked using the lock button (6). To stop the
machine, press the trigger switch again.
In continuous operation, the machine
continues running if it is forced out of
your hands. Therefore, always hold the
machine with both hands using the handles
provided, stand in a safe position and concen-
trate.
7.2

Selection of direction of rotation

Do not activate the rotation selector
switch (4) unless the motor has
completely stopped.
Select direction of rotation:
R = Clockwise
L = Counter-clockwise
The drill chuck must be firmly screwed
onto the spindle and the safety screw
inside the drill chuck must be firmly
tightened with a screwdriver. (Caution, left-
handed thread!) If rotated counterclockwise
(e.g. when screwing) it could otherwise
become loose.
7.3 Tool change with a geared chuck (2)
See illustrations, page 3.
Clamping tool:
Insert the tool and use the chuck key (1) to
uniformly clamp tight in all 3 bores.
Removing tool:
Open the geared chuck (2) with chuck key (1) and
remove tool.
7.4

Tool change

Keyless chuck Futuro Plus (3)
See illustrations, page 3.
Insert tool. Hold ring (a) and turn the sleeve (b) with
your other hand in direction "GRIP, ZU" until
further rotation is impossible.
With a soft tool shank, retightening may be
required after a short drilling period.
Opening chuck: Hold ring (a) and turn the sleeve (b)
with your other hand in direction "AUF, RELEASE".
If the chuck is very securely tightened: Unplug.
Hold drill chuck using an open-end spanner at the
flats on its head and turn the sleeve (b) vigourously
in direction of "AUF, RELEASE".
ENGLISH
ENG
7