Additional Warnings; Functional Description; Special Product Features - Metabo MHE 96 Instrucciones De Manejo

Before using this power tool, carefully read
through and familiarise yourself with all the
enclosed safety information (red booklet)
and the instructions. Keep all enclosed
documentation for future reference, and pass on
your power tool only together with this documen-
tation.
For your own protection and for the
protection of your power tool pay atten-
tion to all parts of the text that are
marked with this symbol!
Pull the plug out of the plug socket before any
adjustments or servicing are performed.
Always work with the additional handle correctly
installed.
A damaged or cracked additional handle must be
replaced. Never operate a machine with a defec-
tive additional handle.
Always hold the machine with both hands using
the handles provided, stand securely and concen-
trate.
Always wear protective goggles, gloves, a dust
mask and sturdy shoes when working with this
tool.
Always work with the tool attached correctly. Pull
on the tool to check that it is seated correctly. (It
must be possible to move the tool a few centime-
tres in an axial direction.)
When working above ground level, make sure that
the area underneath is free.
Do not touch the tool or parts close to the tool
immediately after stopping work because they
may still be extremely hot and could cause skin
burns.
Always lay the power cable away from the back of
the machine.

Additional Warnings:

Some dust created by
WARNING
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from
chemicallytreated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed to
filter out microscopic particles.
California Prop 65 08_2018
SYMBOLS ON THE TOOL:
....Class II Construction
V ........volts
A ........amperes
Hz ......hertz
W .......watts
BPM ..beat per minute
~
........alternating current
n .......no load speed
0
rpm....revolutions per minute

4 Functional Description

See page 3.
1 Bow handle
2 Front thread for additional handle
3 Clamping knob
4 Tool lock
5 Switch button
6 Additional handle
7 Rear thread for additional handle
8 Metabo VibraTech (MVT): integrated damping
system
9 Trigger
10 Locking button for continuous activation *
11 Carbon brush service indicator (lamp signal
for pending carbon brush change)
12 Adjusting wheel for setting the impact force
and speed
* model-dependent

5 Special Product Features

• Three rubber handles provide flexible grip in any
working position
• Metabo VibraTech (MVT): integrated damping
system in the bow and additional handles for
reduced vibrations and less stress on the hands
• Additional handle can be attached to the
housing at 3 different points
• Adjusting wheel for setting the impact force and
speed. For working on softer materials such as
brick.
• Lockable switch for convenient operation
during continuous chiselling
• Electronic smooth start-up for precision drilling
• Die cast aluminium gear housing for optimum
heat dissipation and stability
• Service indicator for signalling pending carbon
brush changes
ENGLISH
ENG
7