Functional Description; Initial Operation; Power-Supply Connection - Metabo MAG 32 Instrucciones De Manejo

17027034_0710 MAG 32 MAG 50 NAFTA.book Seite 7 Mittwoch, 28. Juli 2010 10:03 10
Do not expose the machine to rain and do not use
in wet or potentially explosive rooms.
Disconnect the mains plug from the plug socket
before performing any adjustments or mainte-
nance on the machine. Caution! When you unplug
the mains plug, the magnet loses its holding
power.
If (after use) the magnetic drill stand is placed on a
material with low heat-dissipation characteristics
for a long period (e.g. plastic), the magnet must not
be switched on because this could lead to over-
heating of the magnetic coils.
Follow the instructions for lubrication and tool
replacement.
Keep the handles dry, clean and free of oil and
grease.
Caution! The use of other tools and accessories
can result in a risk of injury.
Use the handle (4) on the magnetic drill stand
when transporting the machine.
Always wear a safety harness when
working on scaffolds.
Wear ear protectors.
Wear protective goggles.
Danger - electrical voltage.
Danger - magnetic field.
Persons with pacemakers prohibited.
Symbols on the tool:
V............... volts
A............... amperes
W.............. watt
Hz............. hertz
.../min....... revolutions per minute
~............... alternating current
n ............. no load speed
0

4 Functional Description

See page 3 (please unfold).
1 Securing strap
2 Ratchet on securing strap
3 Two holding points
4 Handle
5 Container for cooling lubrication unit
6 Supply cock on cooling lubrication unit
7 Threaded pins for adjusting backlash of the
side plate
8 Thumbwheel (1st /2nd gear) *
9 Slot in machine neck for driving out tools *
10 Removal tool *
11 Drill spindle with tool attachment (MK 2) *
12 Setting wheel (speed adjustment) *
13 Electronic signal indicator*
14 Slide plate
15 Lever for moving driving unit up and down
16 Switch (switching on driving unit)
17 Switch (switching off driving unit)
18 Switch (switching on/off magnet)
19 Switch (direction of rotation) *
20 Magnet block/Magnet
21 Tool holder threaded pins*
22 Tool holder (Weldon, 19 mm) *
23 Anti-twist device*
* depending on fittings/model

5 Initial Operation

Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the rating label, match with your power
supply.
Check the machine for possible damage:
Before using the machine, you must carefully
check protective devices or slightly damaged
components to ensure they are operating perfectly
and as intended. Check that moving parts are in
perfect working order and do not jam and check
whether parts are damaged. All parts must be
correctly installed and fulfil all conditions neces-
sary to ensure the perfect operation of the
machine. Damaged protective devices and parts
must be repaired or replaced according to specifi-
cations by an authorised specialist workshop.
5.1

Power-Supply Connection

The machine is in protection class I and must
therefore only be connected to sockets earthed
according to specifications.
Regularly check the power cable on the power tool
and have it repaired by an approved expert if
damaged.
If an extension cord is needed, it must be a three-
core lead with a protective (earth) contactor that is
properly connected to both the plug and the
coupler of the cord.
ENGLISH
ENG
7