Assembly And Adjustments - DeWalt DC411 Manual De Instrucciones

ASSEMBLY AND ADJUSTMENTS

Attaching Side Handle
The side handle (E) can be fitted to either
side of the gear case in the threaded holes.
Before using the tool, check that the handle
is tightened se cure ly.
To improve user comfort, the gear case will
rotate 90° for cutting operations.
Rotating the Gear Case
WARNING: To reduce the risk of serious personal injury,
turn tool off and and remove battery pack before making any
adjustments or removing/installing attachments or accessories.
1. Remove the four corner screws attaching
the gear case to motor housing.
2. Without separating the gear case from
motor housing, rotate the gear case head
to desired position.
NOTE: If the gear case and motor housing
become separated by more than 1/8"
(3.17 mm), the tool must be serviced and
re-assembled by a D WALT service center.
E
Failure to have the tool serviced may cause
brush, motor and bearing failure.
3. Re-install screws to attach the gear case to the motor housing.
Tighten screws to 20 in.-lbs. torque. Overtightening could cause
screws to strip.
Accessories
It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See pages 14 and 15 for
information on choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other accessories
running over their rated accessory speed may fly apart and cause
injury. Threaded accessories must have a 5/8"-11 hub. Every
unthreaded accessory must have a 7/8" (22.2 mm) arbor hole. If it
does not, it may have been designed for a circular saw. Use only the
accessories shown on pages 14 and 15 of this manual. Accessory
ratings must always be above tool speed as shown on tool nameplate.
E
Mounting Guard
MOUNTING AND REMOVING GUARD
WARNING: To reduce the risk of serious personal injury,
turn tool off and and remove battery pack before making any
adjustments or removing/installing attachments or accessories.
CAUTION: Guards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding
with conventional sanding discs. A Type 27 guard (intended for use
with depressed center grinding wheels [Type 27 and Type 29], sanding
flap discs, wire wheels and wire cup brushes) is available at extra cost
from your local dealer or authorized service center. Grinding and
cutting with wheels other than Type 27 and 29 require different
accessory guards not included with tool. A Type 1 guard is provided
for use with the Type 1 wheel. Mounting
instructions for accessory guards are shown
below and are also included in the accessory
package.
1. Open the guard latch (K), and align
the lugs (L) on the guard with the slots on
the gear case (M). This will align the lugs
on the guard with the slots on the gear
case cover.
13
L
M
K