Bestron PURE & CLEAN ABG450RSE Manual Del Usuario página 33

CLEANING AND MAINTENANCE - Changing the dust bag
1. Change the dust bag immediately once the
'dust bag full' indicator turns red, see Figure 7
on page 25.
2. Open the cover by pulling the cover release
(dust bag) upwards. Remove the dust bag from
the holder, and dispose of it in a dustbin.
3. Fit a new dust bag in the holder and press into
position.
4. Close the cover, and press until it clicks into
place.
ATTENTION:
• It is possible that the indicator turns red whilst the dust bag is not yet full. If so, then the nozzle, hose or
tubes may be blocked. These will then need to be cleaned.
• Make sure that the dust bag does not become pinched by the cover. This could damage the appliance
and/or the dust bag.
TIPS
Dust bags for this vacuum cleaner are available from every major hardware store, with a statement of the
type number Bestron D00013.
CLEANING AND MAINTENANCE - Cleaning or replacing the motor safety filter
Clean or replace the motor safety filter at least twice
a year, and more frequently if the filter is visibly
blocked.
1. Remove the plug from the wall socket.
2. Remove the hose from the vacuum cleaner.
3. Open the cover by pulling the cover release
(dust bag) upwards. Remove the dust bag, see
Figure 7. Remove the motor safety filter holder,
located behind the dust bag: see Figure 8.
4. Dispose of the filter, or wash it in lukewarm
water. Allow it to dry thoroughly.
5. Return the cleaned or new filter to its holder, and fit the holder in the appliance. Fit a dust bag. Close the
cover, and press until it clicks into place.
ATTENTION:
• Water could penetrate into the appliance if the filter is not thoroughly dry. This could result in (electrical)
damage.
• Make sure that the dust bag does not become pinched by the cover. This could damage the appliance
and/or the dust bag.
CLEANING AND MAINTENANCE - Replacing the exhaust filter
Replace the exhaust filter at least twice a year, and
more frequently if the filter is visibly blocked.
1. Remove the plug from the wall socket.
2. Open the exhaust-filter cover by pulling on the
lip on the cover. Remove the exhaust filter from
the appliance, see Figure 9.
3. Rinse the filter in lukewarm water. Allow it to dry
thoroughly.
4. Return the cleaned filter to the appliance. Close
the cover, and press until it clicks into place.
33
EN