Mounting The Saw To Astable Surface; Attach Horizontal Work Clamp - Delta ShopMaster S26-260L Manual De Instrucciones

MOUNTING THE SAW TO A
STABLE SURFACE
To ensure safe and accurate operation,
this saw should be mounted to a stable
and level surface such as a workbench. To mount the tool
to a stable surface, refer to Figure 4 and do the following:
1. Locate the four mounting holes in the base of the saw
(A).
2. Secure the tool to the mounting surface using 3/8"
diameter machine bolts, lock washers, and hex nuts
(not included). Make sure the bolts are long enough to
accommodate the saw base, lock washers, hex nuts,
and the thickness of the workbench.
3. Tighten all four bolts securely.
4. Check to make sure that the saw is secure before
operation.

ATTACH HORIZONTAL WORK CLAMP

The horizontal work clamp secures the workpiece to the
fence to provide more stability and keeps the workpiece
from creeping toward the saw blade. To install the
horizontal work clamp, see Figure 5 and do the following:
1. Place the clamp shaft (B) in either hole (C) on the
miter table base.
2. Rotate the knob (D) on the clamp clockwise to move
it in or counterclockwise to move it out as needed.
ASSEMBLY
A
A
D
B
C
10
FIGURE 4
FIGURE 5
A
A