Electrical Connection; Polarized Plugs; Extension Cords; Features - Delta ShopMaster S26-260L Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRICAL CONNECTION

This tool has a precision-built electric motor. It should be connected to a POWER SUPPLY THAT IS 120 VOLTS, 60 HZ,
AC ONLY (NORMAL HOUSEHOLD CURRENT).
Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power
and the motor will overheat. If the tool does not operate when plugged into an outlet, double-check the
power supply.

POLARIZED PLUGS

To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This plug
will fit in a polarized plug only one way. If the plug does not fully fit in the outlet reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

EXTENSION CORDS

When using a power tool at a considerable distance from a power source, be sure to use an extension cord that has
the capacity to handle the current the tool will draw. An undersized cord will cause a drop in line voltage, resulting in
overheating and loss of power. Use the chart to determine the minimum wire size required in an extension cord. Only
round jacketed cords listed by Underwriter's Laboratories (UL) should be used. When working outdoors with a tool,
use an extension cord that is designed for outside use. This type of cord is designated with "WA" on the cord's jacket.
Before using any extension cord, inspect it for loose or exposed wires and cut
or worn insulation.
Keep the extension cord clear of the work area. Position the
cord so that it will not get caught on lumber, tools or other
obstructions while you are working with a power tool. Failure to do so can
result in serious personal injury. Check extension cords before each use. If
damaged replace immediately. Never use tool with a damaged cord, since
touching the damaged area could cause electrical shock resulting in serious
injury.
PRODUCT SECIFICATIONS
POWER CONNECTIONS

FEATURES

Cutting Capacity
(maximum nominal
lumber sizes)
Net Weight
Input
Blade Arbor
Blade Diameter
No Load Speed
6
**Ampere rating (on tool data label)
12A – 16A
Cord Length
Wire Size
25'
14 AWG
50'
12 AWG
** Used on 12 guage - 20 am circuit
NOTE: AWG = American Wire Guage
0º Miter/0º Bevel: 2"x6" or 4"x4"
45º Miter/0º Bevel: 2"x4"
0º Miter/45º Bevel: 2"x6"
45º Miter/45º Bevel: 2"x4"
31lbs
120V~, 60hz, 15 Amps
5/8"
10"
5,500 r/min (RPM)

Publicidad

Tabla de contenido
loading

Tabla de contenido