Dmx Values; Display Intensity - Futurelight Spotlite MH-860 Manual Del Usuario

standard operation.
Use the [Up] and [Down] keys to select "Off" if you wish to switch the lamp light sensor Off and
press [Enter] to confirm or [Mode] to cancel and return to the menu.
Important: The option"Off" is for "emergency operation" only if the lamp light sensor is
defective and you will wait for a delivery of the spare light sensor! If the lamp light sensor
was switched Off, the error messages "LAEr,SnEr,HEAt" will not appear on the display (only
the message "HEAt" will appear if the lamp was turned Off and On within 5 minutes ) and at
switching On of the lamp the electronics will still try to ignite the lamp until it shines (even when
the lamp is damaged or absent), on this account some electronics parts could be damaged!

- DMX values

Readout DMX values of each channel received by the fixture. Use the [Up] and [Down] keys to select
desired channel and press [Enter] to read its value coming to the fixture or [Mode] to cancel and return to
the menu.
- Display-adjusting
This function allows you to adjust the display settings:

- Display intensity

With this function, you can adjust the display-intensity from 20 % to 100 %. Use the [Up] and
[Down] keys to select the level of the display-intensity and press [Enter] to confirm or [Mode]
to cancel and return to the menu.
- Display-reverse
With this function, you can rotate the display by 180°. Use the [Up] and [Down] keys to select
"normal display" or "display turned by 180°" and press [Enter] to confirm or [Mode] to
cancel and return to the menu.
- Display-On
This function allows you to keep the display on or to turn off automatically 2 minutes after last
pressing any key on the control board. Use the [Up] and [Down] keys to select "On" if you wish
to keep the display on or "Off" if you wish to turn off automatically 2 minutes after last pressing
any key on the Control Board and press [Enter] to confirm or [Mode] to cancel and return to the
menu.
- PAN/TILT-Feedback:
This function allows to return the Mowing Head to the required position after changing the position by
external force (e. g. by stroke). Use the [Up] and [Down] keys to select "On" if you wish to enable this
function or "Off" if you wish not to return the Moving Head to the required position and press [Enter] to
confirm or [Mode] to cancel and return to the menu.
Note: If feedback was switched Off, the PAN/TILT-position is changed by external force and feedbeck is
switched On again, the Moving Head might not to be synchronized with the DMX signal. You have to make a
reset in order to synchronize the Moving Head with the DMX signal.
- Lamp off via DMX
This function allows you to switch off the lamp by DMX. Use the [Up] and [Down] keys to select "On" if you
want to switch off the lamp by DMX or "Off" if you don't want to switch off the lamp by DMX and press
[Enter] to confirm or [Mode] to cancel and return to the menu.
46