Trouble Shooting; Error Codes - Springline Nina Manual De Instrucciones

Trouble shooting

If the device does not work properly, please check the following steps:
1. Check if the manual was followed precisely and correctly.
2. Check the following table for possible reasons.
3. Check if all fuses are working

Error codes

Error
code
The lid is not properly
E 02
closed.
The temperature sensor is
E 05
defective.
There is a short circuit at
E 06
the temperature sensor.
There is insufficient water
E 09
in the mixing container.
There is too much flour in
E 14
the mixing container
There is too much dough
E 15
residue in the mixing
container.
E 17 The scale is defective.
Issues with the appliance
Problem
There are more dough
remains than expected.
Problem
It may happen that not all the dough is pushed out by
the extruder screw. You can manually start the Extrude
programme to have the appliance press out dough again.
Close the lid.
Contact customer services.
Contact customer services.
Adjust the liquid ratio.
Only use 200-600 g flour.
Remove the dough residue.
Contact customer services.
Solution
Solution
27