Kreg Jig K4 Manual De Instrucciones página 7

2
Drill Guide Adjustment
To ensure the exit-point of your screw is at
the center of the workpiece, (for the strongest
joint possible) you'll need to adjust position of
your Pocket-Hole by raising or lowering the
Drill Guide's height to match your workpiece
thickness. Loosen the Drill Guide Pin, lift the
Drill Guide until the correct mark is showing
just above the jig body, and re-tighten the pin.
3
Clamp Pad Adjustment
For a fi rm hold on the workpiece, you may
have to adjust the position of the clamp pad.
To do so, release the lock-nut, rotate the clamp
pad in or out, and test the hold by depressing
the toggle. Repeat this process until you get a
secure hold on the workpiece. Then, re-tighten
the lock-nut.
®
Kreg Jig Settings
Drill Guide shown set for 3/4" material.
Release lock-nut, adjust clamp pad
position, test hold, and re-tighten lock-nut.
www.kregjig.com