Ce Declaration Of Conformity; Mesto Spritzenfabrik - MESTO CLEANER Serie Instrucciones De Uso

Ocultar thumbs Ver también para CLEANER Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
GB
IRL
Fault
The nozzle does not
spray even though
pressure is present
The shut-off valve does
not close.
Liquid emerges without
the lever being activated.
Contact address for additional information → Title page.
Warranty
We guarantee that from the time it is first purchased for a period of the legally valid required
warranty period (maximum 3 years) this device will not exhibit any material or processing
errors. If defects are discovered during the warranty period, MESTO or the distributor in
your country will repair the device without charging for the labor or material or (at the
discretion of MESTO) replace the device itself or its defective parts.
If such defects are discovered, please contact us immediately. We require the invoice or
cash register receipt for purchase of the device.
The warranty does not include wearing parts (seals, O-rings, diaphragm, etc.) or defects,
which have occurred due to improper use or unforeseeable circumstances.

CE Declaration of Conformity

In accordance with EC Directive 2006/42/EC, Annex II, No. 1A.
We,
MESTO Spritzenfabrik Ernst Stockburger GmbH
Ludwigsburger Straße 71, D-71691 Freiberg
declare under our sole responsibility that the pressure spraying devices of the series 3275, 3278,
3270, as supplied from factory number AE2 meet all the relevant requirements of Directive
2006/42/EC of the EU.
Furthermore the devices correspond to Directive 97/23/EC for Pressure Equipment.
Rolf Rehkugler is authorized to compile the technical documentation.
Freiberg, 01/01/2014
Bernd Stockburger
– Managing Director –
AUS
USA
Cause
Nozzle [17] (Fig. 19) or / and
filter [18] (Fig. 20) is clogged.
O-ring [23] of the pressure bolt
[24] is not greased / lubricated.
(Fig. 22)
Faulty O-ring [23] or pressure
bolt [24]. (Fig. 21)
17
NZ
CDN
Remedy
Clean the filter or / and nozzle.
Grease the O-ring of the
pressure bolt (dismantle shut-
off valve → section "Care and
maintenance")
Replace O-ring or pressure
bolt.
IND

Publicidad

Tabla de contenido
loading

Tabla de contenido