La-Z-Boy Power Ease Instrucciones De Operación página 7

Power Ease
Assembly Instructions:
The following Back Assembly Instructions are for chair or sofa backs having a
loose upholstery cover with fastening tape. Refer to the instructions on the
previous page if your chair or sofa backs have upholstery cover attached to
all sides of the back frame.
WARNING - To reduce the risk of injury.
• Do not operate the unit until the back(s) are installed and locked.
CAUTION
- To reduce the risk of minor injur y.
• Once the back(s) are installed, the outside back upholstery cover(s) must
be secured in place at all times.
CAUTION – Do not plug the transformer(s) in until instructed.
Install the chair or motion sofa back(s)
1. Lay the back across the arms of the body. Lift the back at a slight angle and
align the brackets on the back with the brackets on the body (F
2. Lower the back onto the body, making sure the back and body brackets are
completely engaged.
• To make sure the back is properly installed with both sets of back and
body brackets engaged, stand behind the unit and twist the back from
side to side. If one or both sides move out of position the brackets are
not engaged (F 2). Remove the back and repeat the steps above.
IGURE
• If you are unable to install the back properly contact your La-Z-Boy
dealer for assistance.
3. Lock the brackets using a slotted screwdriver to push down the locking levers;
do this for each bracket (F
IGURE
locked down.
4. Keeping hands away from the internal frame parts, attach the outside back
upholstery cover to the body of the unit by pulling the back cover tight and
pressing the fastening tape on the back upholstery cover to the fastening tape
on the body (F 4).
IGURE
5. Repeat the above steps to install the remaining back(s) on a motion sofa unit.
6. Return to the Power Ease TM Recliner or Motion Sofa Assembly Instructions to
finish assembly.
12
Back
TM
IGURE
3). For proper operation the brackets must be
F
IGURE
Body
Bracket
Back
Bracket
1).
F
IGURE
®
Back
Bracket
Power Ease
TM
Assembly Details:
F
1
IGURE
Back and body brackets on this
side are not engaged. Remove
the back and reinstall.
3 F
IGURE
Locking
Lever
Locked
Position
Back
2
4
Fastening
Frame
Tape
Parts
13