Factory Reset - Scansonic DA 310 Serie Manual De Instrucciones

90
OFF
2. The system is now set to turn off after the number of minutes you have
set. The display will show "SLEEP #", e.g. "SLEEP 10" means the unit
will switch itself off after 10 minutes, "SLEEP 20" means the unit will
switch itself off after 20 minutes, and so on.
3. Press SLEEP to show the reminding time till the unit switches off
minutes and return back to previous screen.
4. To cancel the sleep timer press SLEEP repeatedly until "Sleep OFF"
shows on the display.
EQ control
the system supports a variety of equalizers and sound effects.
During playback, press EQ on the remote control to select a desired music
mode. Each time EQ is pressed, the music mode will change to the next
one as follows:
FLAT
System reset
There may be times when you need to reset your unit back to the factory
settings especially when you have moved house. If you experience
reception problems you may want to reset and try again. If you move to
another part of the country and pick up the local and national DAB stations
in that area, your previously tuned channels may no longer be available.
1. During DAB mode, open the CD Disk tray
then press and hold STOP on the unit until
the display show "Restarting... FACTORY
RESET".
2. When successful reset, it will back to DAB mode.
After the system reset, all the tuned stations, FM/DAB preset
stations will be erased.
DAB operation
If the unit is connected to the mains power and then switched on from
standby for the irst time, the unit will automatically enter into the DAB
mode and perform auto scan function. During the scan the display will show
"Scanning..." together with a slide bar that indicates the progress of the
scan and the amount of stations that have been found so far.
80 70
10 20
CLASSIC ROCK
60 50
30 40
POP JAZZ
Restarting . . .

FACTORY RESET

13