Scansonic DA 310 Serie Manual De Instrucciones página 15

2. Press PRESET to select your desired preset station number.Then
press ENTER conirm.
3. The station will be stored in few seconds and the screen will then show
"Preset # Stored".
Recalling a stored station
1. Once you have saved a station to one of the preset buttons, you can
recall it by pressing MEMORY.
2. Press PRESET until your desired station show on the display; Then
press ENTER conirm into stations.
the stored stations will be saved into the memory and power off will
not erase it. Storing a new station into a preset location will erase
the previously stored station in that location.
DAB display modes
Press DISPLAY on the remote control, the display will switch through the
following display modes.
The information of each display mode is displayed on the lower segment of
the display.
Ensemble
This displays the name of the multiplex that contains
the station you are listening to. A multiplex is a
collection of radio stations that are bundled and
transmitted on one frequency. There are national
and local multiplexes. Local ones contain stations
that are speciic to that area.
DAB - unlike normal radio, groups together
several radio stations and transmits them
on one frequency.
Signal Strength
This shows a slide bar to indicate the signal
strength, the stronger the signal, the longer the bar
will be from left to right.
Time/Date
This displays the current time and date provided
automatically by the broadcaster.
Ensemble
Signal Strength
Time / Date
DLS
Programme Type
Audio Bit Rate
Frequency
15