Scansonic DA 310 Serie Manual De Instrucciones página 23

Hints and tips
If a problem occurs, it may often be due to something very minor. The
following table contains various tips:
Problem
No power
The remote
control does
not function
The unit does
not respond
when pressing
any buttons
CD
The disc does
not play
Disc skips
Radio
Desired station
not found
USB
USB port not
charging
Bluetooth
I cannot ind
"BT speaker N"
my Bluetooth
device
If any functional abnormality is encountered, unplug the unit from
the mains socket and reconnect it again.
Solution
Ensure the mains cable is connected securely at both ends.
Make sure that the ON mode is selected.
Use the remote control near the unit.
Point the remote control at the remote sensor on the unit.
Replace the battery in the remote control with a new one.
Remove any obstacles between the remote control and the unit.
The unit may freeze up during use. Switch the unit off and then on again
at he mains socket to reset the unit.
There is no disc inside the unit ("No Disc" appears on the display).
Insert the disc correctly with the label side facing up.
Clean the disc.
PAUSE mode may be activated, deactivate it.
A non-valid disc has been inserted.
Condensation may have formed inside the unit due to a sudden change
in temperature. Wait about an hour for it to clear and try again.
Make sure the unit is on a secure spot. Vibrations or jarring can cause
the disc to skip.
Weak signal. Use the Manual Tune function.
No DAB coverage in your area or poor reception.
Adjust the position of the aerial.
Not all device are compatible with USB charging.
Ensure the Bluetooth function is activated on your Bluetooth device.
23