Pioneer PDK-FS07 Manual De Instrucciones página 5

2
Attach Plasma Display to support column.
Fit the stand's support columns into the slots in the center of
the bottom of the Plasma Display then slowly insert them
directly into the slots. Be extremely careful not to insert the
support columns of the stand into any part of the Plasma
Display other than the stand insertion slots. Note that doing so
might damage the Plasma Display panel or its ports or result
in the warping of the stand.
If the Plasma Display is fitted with handles, it is usually best to
hold the display by its handles when attaching it to the
support column.
Be sure to work with at least one other person
when attaching the display.
Be careful not to allow your fingers get caught
Caution
between the display and support column.
Line up the column supports
with the bottom of the Plasma
Display as indicated in the
accompanying diagram.
Installation and assembly instructions
3
Use the short, the middle or the long hexagonal
bolts to fix the Plasma Display to the support
column (4 locations).
Please install starting with the bolts on the top.
When installing the 50 inch display model
Use the following bolts to fix it with the hexagonal wrench.
Top .......... Middle hexagonal bolts (M8 x 40 mm [1-9/16 inch]: black)
Bottom ... Short hexagonal bolts (M8 x 30 mm [1-3/16 inch]: black)
It you are attaching speakers, do so at this stage.
See the installation instructions provided with your
speakers for instructions on how to install them.
When installing the 42 inch display model
Use the following bolts to fix it with the hexagonal wrench.
Top .......... Long hexagonal bolts (M8 x 60 mm [2-3/8 inch]: silver)
Bottom ... Short hexagonal bolts (M8 x 30 mm [1-3/16 inch]: black)
Middle hexagonal bolts
(M8 x 40 mm [1-9/16 inch]: black)
Short hexagonal bolts
(M8 x 30 mm
[1-3/16 inch]: black)
Long hexagonal bolts
(M8 x 60 mm [2-3/8 inch]: silver)
Short hexagonal bolts
(M8 x 30 mm
[1-3/16 inch]: black)
5
En