ASSEMBLY
INSTALLING THE WHEELS
See Figure 6.
Wheels are provided to assist in moving the generator to the
desired location and should be installed on the side opposite
the recoil starter.
Locate the following items:
2 axles
2 spacers
4 washers (5/8 in.)
2 hitch pins
2 wheels
Raise the handle end of the generator high enough to
gain access to the frame bottom; securely position props
underneath to support.
Insert the axle bolt through the spacer, then into the
center of the wheel.
Place a washer on the axle bolt, then slide the axle bolt
through the bracket on the frame.
Place a second washer on the axle bolt then install a
hitch pin to secure.
Repeat the process on the other side to install second
wheel.
12 — English