Metabo HPT DH 36DMA Instrucciones De Seguridad Y Manual De Instrucciones página 15

3. When drilling at "rotation + hammering"
CAUTION
If you switch the selector lever during motor
rotation, the tool can start to rotate abruptly,
resulting in unexpected accidents. Be sure to
switch the selector lever when the motor is at a
complete stop.
(1) Switching to "rotation + hammering"
(a) Turn the selector lever.
(b) Align ▲ of the selector lever and
cover as illustrated in Fig. 15.
Selector lever
NOTE
Turn the selector lever to check if it is completely
locked and make sure that it does not turn.
4. When crushing and chipping at "hammering":
CAUTION
○ If the selector lever is switched during motor
rotation, the tool can start to rotate abruptly,
resulting in unexpected accidents. Make sure to
switch the selector lever when the motor is at a
complete stop.
○ If the bull point or cold chisel is used at the
position of "rotation + hammering", the tool can
start to rotate, resulting in unexpected accidents.
Make sure that they are used at the positon of
"hammering".
(1) Switching to "hammering"
(a) Turn the selector lever.
(b) Align ▲ of the selector lever and
cover as illustrated in Fig. 16.
Fig. 14
of the crank
Fig. 15
of the crank
NOTE
Turn the selector lever to check if it is completely
locked and make sure that it does not turn.
(2) When fi xing working positions of tools such as cold
chisel, etc.,
(a) Turn the selector lever.
Align ▲ of the selector lever and
cover as illustrated in Fig. 17.
Selector lever
(b) Turn the Grip or the Tool as illustrated in Fig. 18
and fi x the tool to the desired working direction.
Tool
(c) Switch the selector lever to "hammering"
according to the procedures mentioned in the
above item (1) and secure the position of the tool.
5. Install the stopper (Fig. 19)
(1) Loosen the wing bolt, and insert the stopper into the
mounting hole on the side handle.
(2) Adjust the stopper position according to the depth of
the hole and tighten the wing bolt securely.
English
Selector lever
Fig. 16
of the crank
Fig. 17
Grip
Fig. 18
15