Rating Plate; Cleaning And Maintenance; Safety Information; Cleaning - CASO DESIGN WineComfort Touch A one Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 70
When the LED lights the device is working. You can set the temperature as your desire by
pressing the buttons
20°C.
You can tune the interior light on or off by pressing the "Light" button. The light will switch
off automatically after 4 hours to save energy.
With pushing both buttons
exchange between °C and °F. The temperature in the device depends on the room
temperature, the quantity of bottles and the chosen temperature. Please note that your
device is intended to cool wine. The maximum temperature that can be reached inside the
device cannot be significantly ABOVE the ambient temperature at the setup location.

14.2 Rating plate

The rating plate with the connection and performance data can be founded on the back of
the device.

15 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

15.1 Safety information

Attention
Please observe the following safety notices, before you commence with cleaning the device:
► Prior to commissioning, clean the appliance thoroughly.
► Switch the device off prior to cleaning it and unplug the plug from the wall power outlet.
Remove all content.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.

15.2 Cleaning

Interior space
Wash the inside with a damp cloth soaked in lukewarm water and a bit of mild detergent.
Tip for neutralisation of odors: Wash the inside with a damp cloth soaked in lukewarm water
and baking soda solution. The solution should be about 2 tablespoons of baking soda to a
quarter of water. After cleaning the interior space, leave the oven door open until the interior
of the device is completely dry.
-
+
and
on the panel to adjust the temperature in 1°C steps from 5-
-
+
and
for 5 seconds, the temperature display mode will be
If you press the power button of :
Upper zone -> upper zone is switched on
Down zone -> only down zone starts working
33

Publicidad

Tabla de contenido
loading

Tabla de contenido