Fault Indications And Rectification Of Faults - CASO DESIGN WineComfort Touch A one Manual Del Usuario

16.2 Fault indications and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Your device is not cold
enough or it does not reach
the adjusted temperature:
The light does not work.
Vibrations & too much noise
& door does not close
properly
LED could not display.
LED display error – Lo
Buttons are not functional
Compressor will not start
Dew on the surface of
cabinet
Liquid sound
Condensation formed inside
the cabinet
Error code E2
► If you are unable to solve the problem with the steps shown above, please contact
customer service.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly. Defrost the device.
Contact customer service.
Check to assure that the wine refrigerator is level. Check
the fan. Components are loose.
Device touches the wall.
The door is reversed and not properly installed.
The seal is weak. The shelves are out of position.
Contact customer service.
Room temperature is lower than desired temperature.
The surface of wine cabinet especially the glass door
appear some frost if item in a damp room. This is due to
the moisture in the air coming into contact with the
cabinet. Please wipe it away with dry cloth.
1) The sound of compressor when starts or stops working
2) The flowing sound of refrigerant in the refrigeration
system
3) The evaporating sound of refrigerant in the evaporator
Under the environment with high level of humidity or the
door of wine cabinet has been left open for a long period
or opened frequently, wipe off the door and walls. Open
the door as rarely as possible.
Desired temperature is not reached.
If necessary defrost the device (Please follow the hints for
manual defrosting in chapter cleaning).
Please note
Possible Cause
35