- Do not submerge the device in water.
- Do not touch the device with wet or damp hands or feet, and do not pull on the power supply cable.
- Before connecting the device to the electricity supply, ensure it is halted and that the grid voltage
corresponds to that shown on the data plate of the device.
- Disconnect the device when not in use or when carrying out cleaning work.
- Do not introduce any objects through the protection grille.
- Do not use this device if the protection grille is in a poor state or is incorrectly positioned.
ASSEMBLY
- Position the counterweight in the foot base.
- Secure the base of the column to the foot base using the supplied screws (Fig.1).
- Loosen the fixing ring in order to move the interior tube to reach the required height. Then tighten the
fixing ring again, in order for the telescopic tube to be maintained at the required height.
- Insert the motor equipment and support tube in the telescopic tube using the clamp (Fig.1).
- Tighten the fixing screw of the clamp in order to secure the motor equipment and support tube to the
telescopic tube (Fig.1).
OPERATION
- Once we have checked that the grid voltage corresponds with that shown on the device's data plate and
that the speed selector is in the halt position, connect the device to the grid.
- Select the speed at which we want the device to work, by rotating the speed selector (Fig. 2), in line with
the following values:
- Once the operation speed is selected, the device starts up automatically.
- The devices in the TURBO series have an adjustable head, which you can bend upwards or downwards
in line with your needs (Fig. 3).
0
Halt
1
Slow speed
2
Medium speed
3
Quick speed
13