Connection To An Amplifier; Power Supply And Emergency Power Supply - Monacor PA-1200EX Instrucciones De Montaje

4 Setup
The unit is designed for insertion into a rack
(482 mm /19"), but it can also be used as table
top unit . For rack installation, two rack spaces are
necessary (1 rack space = 44 .5 mm) .
5 Installing an Insertion
1) Prior to installing the insertion, disconnect the
mains plug of the PA-1200EX from the mains
socket .
2) Screw off the corresponding cover panel
(1 and / or 2) for the insertion compartment .
The three-pole connection cable for the
insertion module is fastened to the cover panel .
Remove the cable and connect it to the cor-
responding pin housing of the module (see
operating instructions of the module) .
3) Install the insertion and tighten it with screws .
4) For all further installation steps refer to the
operating instructions of the insertion used .
6 Connections
All connections should only be made by qualified,
skilled personnel and under any circumstances
with the unit switched off .

6.1 Connection to an amplifier

There are two possible ways to connect the unit
to an amplifier:
1 . Connect the outputs PACK 1 (11) and PACK
2 (10) separately to one line input each of the
amplifier (e . g . input for CD player, tape re-
corder) . Use the volume controls of the inser-
tions to adjust the de sired volume .
2 . To feed the mixed signal of both insertions to
the amplifier, connect the output "1 + 2" (9)
to a line input of the amplifier . Use the volume
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
PACK 2
230V~ / 50 Hz
7
5
6
USE ONLY WITH A 250V FUSE
FUSE
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
BALANCED OUTPUTS
1+2
24 V /2 A
8
9
controls of the insertions to adjust the desired
volume and the mixing ratio or fade the signals
in and out .
6.2 Power supply and
emergency power supply
1) To ensure continued operation of the amplifier
after a mains failure, connect a 24 V emer-
gency power supply unit (e . g . PA-24ESP from
MONACOR) to the terminals 24 V⎓ (8) .
Note: If the 24 V voltage from the emergency power
unit is available at the terminals 24 V⎓ , the amplifier
cannot be switched off with the switch POWER (4) .
In case of a mains failure or if it is switched off, the
amplifier is automatically switched to the emergency
power supply .
2) Finally connect the supplied mains cable to the
mains jack (5) first and then to a mains socket
(230 V/ 50 Hz) .
7 Specifications
Outputs
PACK 1: . . . . . . . . . . . . 0 dBm, XLR, bal .
PACK 2: . . . . . . . . . . . . 0 dBm, XLR, bal .
1 + 2: . . . . . . . . . . . . . 0 dBm, XLR, bal .
Power supply
mains voltage: . . . . . . . 230 V/ 50 Hz
power consumption: . . 55 VA
emergency
power supply: . . . . . . . ⎓ 24 V
DC power
consumption: . . . . . . . 2 A
Dimensions (W × H × D): 482 × 89 × 380 mm,
Weight: . . . . . . . . . . . . . 4 .5 kg
Subject to technical modification .
PACK 1
12
GND
0 dBm
PACK 2 PACK 1
10 11
2 rack spaces
7