Warn Provantage 2500 Guide D’installation página 8

Section 4 - Mount the Remote Socket
(optional)
To prevent severe injury or death.
WARNING
Always verify area is clear of fuel lines, fuel tank, brake
lines, electrical wires, etc., when drilling.
To prevent serious injury or death from
WARNING
electrical re:
Never route electrical cables across sharp
edges.
Never route electrical cables near parts that
get hot.
Never route electrical cables through or near
moving parts.
Avoid pinch and wear/abrasion points when
installing all electrical cables.
1. Determine the mounting location for the
remote socket (see Figure 9), drill three
holes and install (see Figures 12 and 13).
10-24 hex nut &
lockwasher
Keyway must point
down
10-24 hex nut & hex
head capscrew
Figure 12 and 13 Remote socket installation
89294A3
MOUNTING
2. Route the wire harness cables to the
desired contactor mounting location.
3. See wiring diagram provided with
contactor for switch wiring details.
NOTE: See wiring diagram provided with
contactor for switch wiring details.
6.4mm (1/4 in.) diameter, 2 places
22.2mm (7/8in.)
22.2mm (7/8in.) diameter
44.5mm (1-3/4in.)
Not to scale. Do NOT use as a template!
WARN INDUSTRIES
11
MOUNTING
Section 5 - Mount the Dash Switch
(optional)
To prevent severe injury or death.
WARNING
Always verify area is clear of fuel lines, fuel tank, brake
lines, electrical wires, etc., when drilling.
To prevent serious injury or death from
WARNING
electrical re:
Never route electrical cables across sharp
edges.
Never route electrical cables near parts that
get hot.
Never route electrical cables through or near
moving parts.
Avoid pinch and wear/abrasion points when
installing all electrical cables.
1. Determine the dash mounting location
for the dash switch (location is pre-
determined on some specific models
- refer to Figure 9). Mount switch using
bracket and supplied fasteners or cut
rectangle slot as shown in Figure 14.
#10x5/8 in. sheet metal screw OR
M5x0.8 hexhead capscrew, M5-0.8
nut, washers.
Figure 14 and 15 Dash Mount Installation
2. Route the wire harness cables to desired
contactor mounting location.
3. See wiring diagram provided with
contactor for switch wiring detail.
36.8mm
(1.45in.)
21.1mm
(.83in.)
Not to scale. Do NOT use as a template!
WARN INDUSTRIES
12
89294A3