Error Messages; Rack Mounting - Sony MB-806A Manual De Instrucciones

Operation

Error Messages

Apart from the normal indications, the following error
messages may appear on the display.
Message Meaning
Err 01 An error has occurred in the backup
memory data.
Err 02 The PLL-synthesized circuit has a
malfunction.
NO TONE As no tone signal is available or a
tone signal other than 32.768 kHz is
being received, the audio signal
output is muted.

Rack Mounting

1
Foot
Pin
Remove the pins inside the feet
with a small screwdriver or similar
tool.
Bottom panel
1
Remove the feet of the tuner before mounting it on
a rack.
2
Mount the tuner on the rack using screws that are
1
at least 12 mm ( / inches) long and that match the
2
diameter of the screw holes on the rack.
12
(US)
Remedy
Contact your nearest Sony dealer.
Contact your nearest Sony dealer.
Make sure that the transmitter is turned on. If it is, then the
problem lies in the transmitter's tone signal generator or the
tuner's tone squelch circuit. Contact your nearest Sony dealer.
If you are using a WRT-810A wireless microphone, a "NO
TONE" message appears when you turn off the AF switch, but
this is normal.
2
Tuner
Rack
Screws