Rack Mounting; Error Messages - Sony WRR-801A Manual De Instrucciones

Rack Mounting

Operation
1
Foot
Pin
Remove the pins inside the feet
with a small screwdriver or similar
tool.
Bottom panel
1
Remove the feet of the tuner before mounting it on
a rack.
2
Mount the tuner on the rack using screws that are
1
at least 12 mm ( / inches) long and that match the
2
diameter of the screw holes on the rack.

Error Messages

Apart from the normal indications, the following error
messages may appear on the display.
Message Meaning
Err 01 An error has occurred in the backup
memory data.
Err 02 The PLL-synthesized circuit has a
malfunction.
NO TONE As no tone signal is available or a
tone signal other than 32.768 kHz is
being received, the audio signal
output is muted.
14
2
Tuner
Remedy
The memory data is initialized. Reset the group and channel
settings.
Contact your nearest Sony dealer.
The transmitter's tone signal is in trouble. Contact your nearest
Sony dealer. If you are using a WRT-810A wireless
microphone, a "NO TONE" message appears when you turn off
the AF switch, but this is normal.
Rack
Screws