Rear Panel - Sony WRR-801A Manual De Instrucciones

Location of Parts and Controls

Rear Panel

6 5
IN(DC 9V OUT)
0 10dB
ATT
ANTENNA B
1 ANTENNA A, B IN / DC 9V OUT (antenna A, B
input/DC power output) connectors (BNC type)
Connect the supplied antenna or an optional AN-820A
UHF Antenna. To connect two of these units, these
connectors are connected to the ANTENNA OUT
connectors of the WD-820A UHF Antenna Divider.
When the AN-820A is connected, 9 V DC power is
supplied to the antenna's internal booster through these
connectors.
Note
Never short-circuit these connectors.
2 ANTENNA A, B ATT (attenuation) switches
Select the RF attenuation as 0 dB or 10 dB. (Normally,
set the switches to 0 dB.)
3 AC IN connector
Connects to an AC power source with the supplied AC
power cord.
8
4 3 2 1
TNNER OUTPUT(LINE LEVEL 0dBm) MIX OUTPUT
5 MIX OUTPUT connector
6 TUNER OUTPUT connectors
1 ANTENNA A, B IN/DC 9V out connectors
2 ANTENNA A, B ATT switches
LEVEL
MIC LINE IN(DC 9V OUT)
–38dBm 0dBm
0 10dB
ATT
ANTENNA A
4 MIX OUTPUT LEVEL switch
4 MIX OUTPUT LEVEL switch
Selects the mixed output level as 0 dBm or –38 dBm.
Set this switch according to the input level of the
equipment connected to the tuner.
5 MIX OUTPUT connector (ø6.3 phone balanced
1
( / inch TRS))
4
Supplies mixed audio signals of six tuner units. You
can connect this to the audio input connector of a
mixer, amplifier or similar equipment.
6 TUNER OUTPUT (tuner sound output)
connectors (ø6.3 phone balanced (
Each connector supplies the audio signal from the
corresponding tuner unit. You can connect this to the
audio input connector of a mixer, amplifier, or similar
equipment.
3 AC IN connector
⁄
AC IN
1 / inch TRS))
4