Maintenance; Cleaning; Service; Lubrication - Heiniger EVO Instrucciones De Uso

Should the power supply be interrupted whilst the drive is running,
for safety reasons the motor switches off automatically, which means
that the unit must be switched on again via the cord / lever when the
power supply is re-established.

4 Maintenance

4.1 Cleaning

Before commencing any maintenance work disconnect the electrical
power supply by pulling out the plug!
Remove any oil and dirt from the shearing plant by means of a dry
cloth. Do not use liquids!

4.2 Service

For safety reasons the portable shearing plant should be subjected
to an annual inspection. It is important that the self-tensioning belt
is checked periodically, since the functionality of the patented safety
cutout device is dependent on this.

4.3 Lubrication

Lubricate the machine in accordance with the following specifica-
tions, since a lack of lubrication is the most common source of faults
for unsatisfactory shearing results.
4.3.1 Shearing plant
Requires no lubrication.

4.3.2 Flexible drive

prior to each period of operation
Oil the flexible drive prior to use, and at least each time the cutters
are replaced (Diag. 7, pos. a).
Diag. 7
EVO Shearing Plant – Instruction Manual 11