Advanced Programming - Dea NET24N Instrucciones De Uso Y Advertencias

5 ADVANCED PROGRAMMING

Here are some added programming procedures relating to remotes memory management and advanced configuration of the control
inputs.
1
Deletion of memorized transmitters
1.1 Deletion of all transmitters
1. Scroll down the parameters until you visualize P004;
2. Confirm by pressing on the
3. When " " is flashing, press the
onds;
4. Release the key as soon as "
5. All memorized transmitters have been deleted (display
shows again P004).
1.2 How to search and delete a transmitter
1. Scroll down the parameters until you visualize P006;
2. Confirm by pressing on the
3. By pressing on and
want to delete (eg.
4. When " " flashes, confirm the deletion by pressing the
key for a few seconds;
5. Release the key when appears "
6. The selected transmitter is deleted (display shows again
P006).
2
Resetting of default parameters
1. Scroll down the parameters until you visualize P007;
2. Confirm by pressing on the
3. When " " flashes, press the
4. Release the key as soon as "
Default parameters for the configuration currently in
use are restored;
6. At the end of the operation display returns to P007.
Warning: After you restore the default parameters, you
must program the control panel again and adjust all ope-
rating parameters, in particular, remember to properly set
the configuration of parameters (P028 - P029 - P030 –
operator configuration).
3
Locking-Unlocking access to programming
By using a "dip-switch" remote (regardless of the type of remotes already memorized) it's possible to lock-unlock access to the pro-
gramming of the control panel to avoid tampering. The remote setting is the locking-unlocking code verified by the control board.
3.1 Locking access to programming
1. Scroll through the parameters with the buttons
and until the display shows P008;
2. Access the parameter by pressing the button
3. The display shows
to indicate that the control board is
waiting for the transmission of the block code;
4. Within 10 seconds press CH1 on the "TX Master",
the display shows
to the list of parameters;
5. Access to programming is locked.
key;
key for a few sec-
" stops flashing;
key;
, keys, select the transmitter you
);
";
key;
key;
" stops flashing;
;
alternately the writing
before returning
63