KitchenAid 720-0787D Manual De Uso página 13

8. Attach door to cart by aligning the screw holes on the
door (E) with the screw holes in the door hinge (L).
Insert the screws into the door hinge then into the
door and tighten as shown below.
Note: Door may misalign when grill is rolled over uneven
ground or positioned on uneven ground. To adjust door
alignment the hinges need to be adjusted. Loosen the screws
marked A securing the door hinges. Hold door and hinges in
desired position and tighten screws to secure the hinges. To
adjust door angle, turn screws marked B clockwise to move
door left and counterclockwise to move door right door left and counterclockwise to move door right.
9 9. Loosen 2 screws which are pre-assembled on the cart L 2 hi h
frame (K) and 2 screws pre-assembled on the heat shield
(F), hang the heat shield between the cart frame and rear
panel of cart by the screws previously loosened, and
tighten screws.
F
L
E
bl d h
K K
Firebox Assembly
1. Remove the 4 screws under the firebox (A) on each
corner. Place the firebox on the cart as shown with the
hose inside the cart and reattach the 4 screws. Tighten
to secure.
Note: Make sure the LP regulator hose is placed through Note: Make sure the LP regulator hose is placed through
the gap area of the heat shield and is inside the cart when
attaching firebox assembly.
A
13