Make Gas Connection - KitchenAid 720-0787D Manual De Uso

NOTE: If grill is to be converted to Natural gas, follow instructions
in the "Gas Conversions" section.
20 lb LP Gas Fuel Tank
LP Gas:
IMPORTANT: A 20 lb LP gas fuel tank must be purchased
separately.
IMPORTANT: The gas pressure regulator/hose assembly
supplied with the grill must be used. Replacement gas pressure supplied with the grill must be used Replacement gas pressure
regulator/hose assembly specific to your model is available from
your outdoor grill dealer.
Door Style Tank Tray
1. Open cabinet door.
2. Slide the tank tray locking bracket counterclockwise 90
degrees and pull out the tray.
A
B
A. Tank tray locking bracket
B. Tank Bolt
3. Place the 20 lb LP gas fuel tank bottom collar into the g
mounting hole in the tank tray.
4. Tighten the tank bolt clockwise against the bottom collar
of the 20 lb LP gas fuel tank to secure.
A.
C
5. Slide the tank tray with the 20 lb LP gas fuel tank
back into the cabinet and lock the locking bracket.
18

Make Gas Connection

A. Locking screw
B. Mounting hole
B
C. Bottom collar
A
A. Tank tray locking bracket
To Connect the 20 lb LP Gas Fuel Tank:
1. Check that the 20 lb LP gas fuel tank is in the "Off"
position. If not, turn the valve clockwise until it stops.
2. Check that the 20 lb LP gas fuel tank valve has the
proper type-1 external male thread connections per t 1 t
ANSI Z21.81.
3. Check that the burner control knobs are in the "Off"
position.
4. Remove any debris and inspect the valve
connections, port, and gas pressure regulator/hose
assembly for damage.
NOTE: Always keep the LP cylinder at 90°(upright)
orientation to provide vapor withdrawal.
5. Using your hand, turn the gas pressure
regulator/hose assembly clockwise to connect to
the 20 lb LP gas fuel tank as shown. e 0 b gas ue a
Hand tighten only. Use of a wrench could damage the
quick coupling nut.
A. Gas pressure regulator/hose assembly
B. 20 lb LP gas fuel tank
Make sure that the cylinder valve connection device
properly mates with the connection device attached to
the inlet of the pressure regulator.
6. Open the tank valve fully by turning the valve
counterclockwise. Wait a few minutes for gas to
move through the gas line.
7. Before lighting the grill, test all connections by g g g ,
brushing on an approved noncorrosive leak-
detection solution. The presence of bubbles will
show a leak.
l l th d ti
as s o
A
y
B