Cleaning The High-Pressure Ilter; Cleaning Airless Spray Gun - Titan IMPACT 1040 Instrucciones De Uso

Ocultar thumbs Ver también para IMPACT 1040:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Impact 1040
8.3
cleANINg The hIgh-preSSure fIlTer
Clean the ilter cartridge regularly. A soiled or
i
clogged high-pressure ilter can cause a poor
spray pattern or a clogged tip.
1. Turn the pressure control knob counterclockwise to
minimum pressure.
2. Open the relief valve, valve position PRIME (k circulation).
3. Switch the unit OFF.
Unplug the power plug from the outlet.
4. Unscrew the ilter housing (Fig. 9, Item 1) with a strap
wrench.
5. Turning clockwise, unscrew the ilter (2) from the pump
manifold (3).
6. Clean all the parts with the corresponding cleaning agent.
If necessary, replace the ilter cartridge.
7. Check the O-ring (4), replace it if necessary.
8. Turning counterclockwise, screw the new or cleaned ilter
into the pump manifold.
9. Screw in ilter housing (1) and tighten it as far as possible
with the strap wrench.
1
2
8.4

cleANINg AIrleSS SprAy guN

i
1. Rinse airless spray gun with an appropriate cleaning agent.
2. Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
3. Thoroughly clean the outside of the airless spray gun.
INTAke fIlTer IN AIrleSS SprAy guN (fIg. 10)
1. Unclip the top of the trigger guard (1) from the gun head.
2. Using the bottom of the trigger guard as a wrench, loosen
and remove the handle assembly (2) from the gun head.
3. Pull the old ilter (3) out of the gun head. Clean or replace.
4. Slide the new ilter, tapered end irst, into the gun head.
5. Thread the handle assembly into the gun head. Tighten
with the trigger wrench.
6. Snap the trigger guard back onto the gun head.
5
3
4
cleaning the unit (shutting down)
Clean the spray gun after each use.
1
3
2
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

05320470532048

Tabla de contenido